need some help

[hilton]

i cant figure it out how can u get power to the ecu but not get it to the sencers if all wires r good,and everything is hooked up and no one can find anything wrong

iit is a 99 eclipse gs it has a fully built slow 420a that i just put in the car


if u have any questions about it just ask

[vr6dub]

what are sencers?

[hilton]

sensor sorry for the miss spell

[pooprajoe]

could be bad ecu, if the ecu gets power and nothing else.

[hilton]

yea i have been looking around today for a 99 ecu but have not found one yet but im also thinking that the car is not grounded anuff so im going to get some ground wires and see

im up for any advise right now i have no idea what the problem is

i checked the power to the ecu and it was the same as the battery and so i checked the power to the sensors and they r like 4 volts low from what they need to be

[GODZILLA]

did you check all the grounds?

[Justin]

Grounds or Ecu.Grounds are easier to check so i'd start there.Get you some of this little washers that eat into the paint to give you a good ground if you have to.

[hilton]

i just went and picked up some wire and a distabution block so that i can ground the whole motor to the chassie so we will see how that goes and go from there

[Andrew]

shits weak.

[hilton]

well my car is going to shop tomorrow so hopefully i they can find out whats wrong with it and i can get it runnung

[hilton]

well its running now so that a good thing all that is left is exhault and intake
but that will be done today

[levo]

what was wrong with it bro...

[hilton]

i had 2 plugs that were switched the coil pack and the speed senser

and the cam shaft senser was bad

[hilton]

car is running great know just have a dead battery so that will be fixed in the morning